[mooney]

Thank you for this how-to guide.

The PDF version of this how-to guide is here: http://www.vvon.co.uk/downloads/Vect...ault_codes.pdf

Thank you.

[Tom]

Cheers mooney...

One question though-

While holding down the accelerator- Won't this flood the engine with fuel?

Do I hold the pedals down throughout the flashes, or just until the light starts flashing then release them?

[phil-h]

Nice one Chris, great list of fault codes m8

[mooney]

	Quote:
	Originally Posted by Tom Cheers mooney... One question though- While holding down the accelerator- Won't this flood the engine with fuel? Do I hold the pedals down throughout the flashes, or just until the light starts flashing then release them?

not quite sure how it would flood the engine, its a fly by wire throttle, as long as the engine isn't started there's no fuel being pumped into the engine.

and yes keep the pedals pressed till the eml has finished flashing, it will repeat all the codes stored

[Tom]

	Quote:
	Originally Posted by mooney not quite sure how it would flood the engine, its a fly by wire throttle, as long as the engine isn't started there's no fuel being pumped into the engine. and yes keep the pedals pressed till the eml has finished flashing, it will repeat all the codes stored

Oh right lol.

Told you I don't know anything about engines

Cheers mate

[bbr620]

tried both methods on my y-reg sri 2.2 and i don't get nothing flashing on the dash, tried holding down brake/accelerator pedal then turning on ignition while keeping pedals down, also tried as above but, releasing and repressing accelerator pedal, turning off ignition and back on, still nothing, i was wanting codes as i have abs/tc lights, now engine orange light is on [not the one with the spanner through it]..

any help, thanks in advance..